Configuration Manual

110

Dual-band 3x3 802.11 ac WiFi Access Point

5.9. Beacon interval of BSS

Beacon interval stands for the time interval of beacon transmissions of

each supported BSS. The unit is in term of millisecond (ms). The beacon

interval can be configured between 40 and 3500ms. The default setting

is 100ms, i.e. 10 beacons per second.

Figure 114 – Beacon Interval Setting

1. 2.4G Interface: Go to Configuration > Wireless > Radio0 > Advanced

> Advanced Settings

5G Interface: Go to Configuration > Wireless > Radio1 > Advanced >

Advanced Settings

2. Select Beacon Interval Auto checkbox AP tunes the interval of

beacon transmissions of each supported BSS automatically.

Enabling is default and recommended setting

3. Enter interval time between 40ms and 3500ms on Beacon Interval;

this option is available if Beacon Interval Auto is NOT enabled. Each

BSS share this setting.

4. Click Submit

5. Click Save & Apply from the top on the right.

5.10. Nearby AP List

Figure 115 – Nearby AP List Setting

To configure nearby AP list, perform the followings:

1. 2.4G Interface: Go to Configuration > Wireless > Radio0(2.4G) >

Advanced > Advanced Settings

5G Interface: Go to Configuration > Wireless > Radio1(5G) >

Advanced > Advanced Settings

2. Select Nearby AP List checkbox to enable that AP sniffs the

surrounding AP periodically; The result list is shown on the

corresponding radios’ status information

3. Click Submit

4. Click Save & Apply from the top on the right.