NS1100 AIR User Guide - English Personal Sound. Hybrid Active Noise Cancelling. NS1100 AIR Scan to download the app To personalize your sound, and control all features you need to download the Nocs Design App to your iOS or Android device.
NS1100 AIR Technical Specifications L a Features • Bluetooth 5.0 • Sound Codecs: SBC, AAC codec • Driver Type: Electrodynamic, 9.2 mm diameter • Driver Sensitivity: 102 ±3dB • Impedance: 16 Ohm • Frequency Range: 20 – 20,000 Hz • IPX5 - nano coating (Dust and splash / sweat resistant) • MEMS Mic: 4 Enabling Hybrid ANC Battery Life Up to 8 hours. 30 hours with charging case at moderate volume. Inputs and Outputs USB-A to USB-C cable for charging. Charging Case 400 mAh Charging Time Earphones: approx.
NS1100 AIR Let’s get you all set up Quick Start Place the earphones in the charging case to charge before your first time use. Charge the case using the USB-C cable and any 5V/1A power supply. Charging time is approximately 2 hours. After use, please place the earphones back into the charging case, it will turn off automatically and save battery. When the NS1100 are charging, the LED will light on in red, and off when fully charged.
NS1100 AIR Introduction Take the earphones out of the case. The master side of the earphones will flash the LED white to indicate it’s in pairing mode. Turn on Bluetooth on your device for searching. Select “Nocs NS1100 AIR” on the Bluetooth searched device list, the earphones will connect to your device. Download the Nocs Design App from App Store or Google Play Store depending on your device. Start the App and choose Nocs NS1100 AIR in the list to connect.
NS1100 AIR Bluetooth Pairing Take the earphones out from the charging case or touch and hold the touch sensor button for 3 seconds to power on. The LED on the master side of the earphones will flash white to indicate it’s in pairing mode. When pairing, please keep the NS1100 AIR and Bluetooth device in 1 meter range and make sure the earphones are turned on.
NS1100 AIR How to use the touch control Left Earphone Function: ANC mode switch Answer / End call Previous track Voice activation Reject call Tou Left Side Operation: Single tap Single tap Double tap Touch and hold for 2 seconds Touch and hold for 2 seconds Right Earphone Function: Play / Pause Answer / End call Next track Voice activation Reject call Right Side Operation: Single tap Single tap Double tap Touch and hold for 2 seconds Touch and hold for 2 seconds User Guide English Ha 6
NS1100 AIR Is there a problem? Toubleshooting The earphones are not connected to each other: Triple tap two times on both sides of the earphones (either one side first or triple tap twice on each side at the same time - the sequence doesn’t matter), then it will re-pair to each other. The pairing list will be cleared and reset back to default.
NS1100 AIR User Guide - English Nocs AB nocsdesign.com hello@nocsdesign.
FCC ID: A48-NS11 FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
