READ AND UNDERSTAND ALL SAFETY INFORMATION BEFORE USING THIS PRODUCT. Failure to follow these safety instructions may result in ELECTRICAL SHOCK, EXPLOSION, FIRE, which may result in a SERIOUS INJURY, DEATH, or PROPERTY DAMAGE. Electrical Shock. Product is an electrical device that can shock and cause serious injury. Do not cut power cords. Do not submerge in water or get wet. Explosion. Unmonitored, incompatible, or damaged batteries can explode if used with product.
Important Safety Warnings About GENPRO Series. The NOCO GENPRO Series on-board battery charger represents some of the most innovative and advanced technology on the market, making each charge simple and easy. It is quite possibly the safest and most efficient charger you will ever use.
AGM, and 12-volt Lithium batteries. Do not attempt to use product with any other type of battery. Charging other battery chemistries may result in injury, death or property damage. Contact the battery manufacturer prior to attempting to charge the battery Do not charge a battery if you are unsure of the battery's specific chemistry or voltage. Medical Devices. Product may emit electromagnetic fields.
Mode Explanation Standby In Standby mode, the charger is not charging or providing any power to the battery. Energy Save is activated during this mode, drawing microscopic power from the electrical outlet. Canbus is enabled in Standby mode. When in Standby, the orange Standby LED will illuminate. (Peak Voltage Measured At 25°C, Amperage Rating Is Bulk Amperage When Above 0°C) 12V 12V AGM 12V LITHIUM 12V REPAIR Press & Hold (3 Seconds) Force Mode Press & Hold (5 Seconds) Using 12V Lithium.
will artifK:ially raise the qJefl circuit voltage of the battery, causing the battery to appear fully charged, ~ proyidirVJ low capooty.Use 1'ZV Repair in attempt to reverse these problems. F« ~timal results, take the 12-wlt battery through a full charge cycle, bringing the battery to full charge, before tsng this mode. 1'ZV Repalr can take up to four (4) hours to complete the recrNery process and will rellm to StanclJy Yti1el1 cooipleted. CAUTION. USE THIS MOOE 'MTH CAPE.
Begin Charging. 1.) Verify the voltage and chemistry of the battery. 2.) Confirm that you have connected the battery clamps or eyelet terminal connectors properly and the AC power plug is plugged into an electrical outlet. 3.) [First time use] The charger will begin in Standby mode, indicated by an orange LED. In Standby, the charger is not providing any power. 4.
Understanding Charge LEDs. LED 25% Red LED 50% Red LED .oo□ The 25% Charge LED will slowly pulse ·on· and ·ott• when the battery 1s less than 25% charged. When the battery is 25% charged, the 25% LED will go solid and the next LED will begin to pulse. ••□□ The 50% Charge LED will slowly pulse •on• and "off" when the battery is 25% - 50% charged. When the battery is 50% charged, the 50% LED will go solid and the next LED will begin to pulse.
i 12V 2V 3 (For GENPR01 OX1 /1 OX2/1 OX3/1 OX4, each bank is isolated and functions independentfy.) I 1.) Mode Button Push to cycle through charging Mooes. 2.) Overvoltage Error LED Illuminates solid Red; Battery Voltage is above Protect voltage. 5.) Standby LED Illuminates when the charger is in Standby Mode, the charger is not charging or providing any power to the battery. 6.) Charge LED indicates the connected battery(s) state-of-charge. . 3.
Technical Specifications GENPR010X1 g,ut~AC: Working Voltage AC: ~ Power: Charging Voltage: Chaqmg Clmlnt Low-Voltage Detection: Back CUmtnt Drain: Ambient Temperature: Type of Batllrtes: Battery Chemistries: Banks: Battery C8paclty: Housing ProtacUon: Cooling: Dimensions (L XWI H): Weight GENPR010X2 120-240 VP£, 50-60Hz 120-240 VAC, 50-60Hz 150x2WMax Various 10Ax2(12V) 1V (12V) <0.
3 Vear Hassle-Free Warranty NOCO warrants that this product (the "Product1 will be free from defects in material and workmanship for a period of Three (3) years from the date of purchase (the "Warranty Period"). Rx defects reported during the Warranty Period, NOCO will, at its discretion, and subject to NOCO's technical support analysis, either repair or replace defective products.
With Receipt 0-3 Years: NO Charge. Wrth proof of purchase, The warranty period begins on date of purchase. With NO Receipt 0-3 Years: NO Charge. Wrth NO proof of purchase, The warranty period begins on the serial number date. We recommend registering }«Ir NOCO product in order to upload proof of purchase and extend your effective warranty dates. You may register your NOCO product online at: no.co/register.
NOCO® GENPRO10 Series.01060120A For more information and support visit: www.no.
