HUB SETUP
Contents: Important information .......................... 1 System setup .................................... 1, 2 Advanced setup ................................... 2 Control via Internet ............................. 3 Remove the HUB ................................. 4 Contact us ............................................
Important information: The HUB communicates with receivers using radio signals. The HUB must be mounted on a wall for optimal range. Some building materials, like reinforced concrete, mass timber, etc. may reduce the signal range. In the case of signals not reaching a receiver, moving the HUB 1-2 metres to the side could be enough to avoid the obstacle. Install the system, and make sure all your receivers react properly, before final mounting of the HUB on the wall.
If more than one HUB is connected to the same wireless network, the correct one must be selected in the setup wizard. Check the ID code at the back of the HUB and select the corresponding ID in the App. NB: Only one HUB can be installed at a time. For security reasons, you will be asked to type in the 3 last digits of your HUB ID code. Do not mount the HUB on the wall until the setup is finished, in case you need to check the ID code again.
Control via Internet: After the app has been connected to the HUB through a local network, it can also be operated later remotely via the Internet. The system security is based on your local network being protected from unauthorised access. Please make sure your local, wireless network is password-protected against intruders. Be careful when allowing others to access your network. Anyone who has connected their app to your HUB, will later be able to control it remotely via the Internet.
Remove the HUB: Removing the HUB from the app means the Energy Control System can no longer be controlled by that particular phone or tablet. Other devices connected to the same HUB will not be affected, and can still be used as normal. To remove the HUB, select “Remove” from the menu, and then HUB. Can’t find what you’re looking for? Contact us: www.nobo.com.au Glen Dimplex Australia Pty Ltd 1340 Ferntree Gully Road Scoresby, VIC 3179 Phone: 1300 556 816 Fax: 1800 058 900 Email: sales@glendimplex.com.
