Warnings: You must read this before you proceed.
Part NO.
Label Picture Description QTY 1 Bolt(M10*20mm) 8PCS 2 Washer 8PCS 3 Screw With Plastic Cap 1PC 4 Allen Key 1PC Before Beginning Assembly: Unpack all the parts for a clear overview.
Step 1 Unpack the package and place all parts on a soft, non marring surface.Fix the 360°Swivel Mechanism with FOOT LEVER(D) to the Base(A) with Bolt(1) and Washer(2) by Allen Key(4). Keep the foot lever angle upward angled. Step 2 Fix the Umbrella Base Pole(E) to 360°Swivel Mechanism with FOOT LEVER(D) with Bolt(1)and Washer(2) by Allen Key(4). Step 3 Place the Plastic Cone (B+C) onto the Umbrella Base Pole (E).
Step 5 Insert the pole of the Umbrella Frame & Canopy (G) onto the Umbrella Base pole (E). Fix the Screw With Plastic Cap (3) in place to ensure that the pole is tightly secured to the base. Step 6 Squeeze and hold the hand grip, push it upwards along the pole to the desired position, then, move the umbrella to an upwards position. Step 7 Insert the Crank(F) to the hand grip on the Umbrella Frame & Canopy (G).
Step 8 For adjusting the umbrella angle,squeeze the hand grip and move upwards or downwards along the pole. Step 9 Test Step on the foot lever on the base and turn the umbrella pole Clockwise or Counterclockwise to the desired direction. Step 10 The umbrella is fully assembled and ready for use.
Page 7 OF 7
