Instructions / Assembly

ManualsBrandsNoble House ManualsOutdoor Lounge FurnitureBaylor 3-Piece Metal Outdoor Sectional Set with Cream Cushions

Assembly Instructions

Caution: You must read this before you proceed

Please look in the Seat Panel for Hardware packs.

Right Loveseat

CAUTION: This Loveseat is NOT a TOY. Keep your child / children at bay

during the process of assembly. For turning the Loveseat and to prevent any

possible damage to it, 2 people may be needed to execute this action.

Noble House Home Furnishings LLC 1 of 8

Summary of content (8 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Please look in the Seat Panel for Hardware packs. Right Loveseat CAUTION: This Loveseat is NOT a TOY. Keep your child / children at bay during the process of assembly. For turning the Loveseat and to prevent any possible damage to it, 2 people may be needed to execute this action.
PAGE 2
Part List Label Picture Description Qty A Leg Panel 2 B Seat Panel 1 C Back Frame 2 D Back Cushion 2 E Seat Cushion 1 Noble House Home Furnishings LLC 2 of 8
PAGE 3
Hardware Label Picture Description Qty ① Bolts (M6x15mm) 13 ② Flat Washer (M6.
PAGE 4
Assembly Steps Overview This Loveseat has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Loveseat parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
PAGE 5
Step 2 Place the Seat Panel (B) facedown onto a clean, non-marring surface as shown in the picture above. Attach the Leg Panel(A) to the Seat Panel(B) using Bolts(①) and Washers(②) with the Allen Wrench(③) as shown in the picture above. Repeat the same process to install the remaining Leg Panel (A) to the Seat Panel (B). Do not fully tighten the Bolts.
PAGE 6
With assistance from your adult partners, attach the Back Frame(C) to the Seat Panel(B) using Bolts(①) and Washers(②) with the Allen Wrench(③) as shown in the picture above. Repeat the same process to install the remaining Back Frame(C) to the Seat Panel(B). Do not fully tighten the Bolts. Step 4 Turn the Loveseat upright, attach the Back Frame(C) to the Seat Panel(B) using Bolts(④), Washers(②) and Sleeve Nuts(⑤) with the Allen Wrench(③) as shown in the picture above.
PAGE 7
Place the Seat Cushion(E) and the Back Cushions(D) onto the Seat Panel(B). Then EXERT pressure, floorwards onto the Loveseat with both hands. This pressure will help the Loveseat reach full alignment at all joints. In a sequential manner, gradually tighten Bolts at all joints until evenly secured. Inspect the Loveseat and make sure all parts are adequately connected. Your Loveseat is ready for use. This Loveseat can only be used on a flat, level surface.
PAGE 8
Noble House Home Furnishings LLC 8 of 8