Instructions / Assembly

Step 16
Put the Cushion (M) onto the assembled part in Step 15, then tie all the strings of the Cushion (M) to
the Right Foldable Seat Panel (A), and the Left Foldable Seat Panel (B) as shown above.
Place the Sun Lounger on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit onto the Sun Lounger.
This will help align all the parts at all joint areas.
Then get off the Sun Lounger and proceed to tighten the Bolts and Screws in a sequential manner.
When tightening the Bolts and Screws, tighten sequentially.
DO NOT tighten any Bolts and Screws fully and then move on towards the next one.
If there are any wobbles after tightening, loosen the Bolts/Screws and execute this same process.
Adjust the Levellers until the Sun Lounger is level with the ground.
To adjust the Levellers, get assistance from an adult partner to lift/lean and hold the Sun Lounger
while you are working.
The Sun Lounger is ready to be used.
This Sun Lounger can only be used on a flat, level surface.
M
Adjust Pre-installed Levellers height for balance
Noble House Home Furnishings LLC
Page 21 of 22