Caution: You should read this before proceeding Chair Label Picture Description QTY A Backrest/Leg 1 B Seat/Leg 1 Page 1 OF 6
Label Picture Description QTY ① Washer(M6) 4 ② Bolt (M6*45mm) 4 ③ Allen Wrench(M6) 1 Before Beginning Assembly: Page 2 OF 6
Overview Backrest/Leg(A) Seat/Leg(B) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is provided to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts onto a clean, non-marring surface. Attach the Seat/Leg(B) to the Backrest/Leg(A) with the Washers(①) and Bolts(②) using the Allen Wrench(③) as shown above. Do not fully tighten any Bolt at this time. Lock tightly at the end.
Stand the Chair up. Place the Chair on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected. Gently and carefully, sit on the Chair. This will help align all parts at all joints. Then get off the Chair, and in a sequential manner, proceed to tighten all Bolts. When tightening the Bolts, tighten sequentially. DO NOT tighten any Bolt fully and then move on to the next one. This may cause the frame to warp.
Page 6 OF 6
