Instructions / Assembly

Step 2

Step 3

Keep the Chair Base(B) as the same position,as shown above.

Install the Front Leg(C) at the bottom of the Chair by placing one Gasket(①) on the

threaded stem.

Install the Hind Leg (D) at the bottom of the Chair by placing one Gasket(①) and

one Silicon Washer(②)on the threaded stem.

Then insert threaded stem into the threaded mounting postion at the corner of the

Chair.

Tighten by turning the Leg clockwise, DO NOT OVER TIGHTEN.

Repeat the same step to install the remaining Leg(C) .

Take care of the shape of the Legs and ensure they are in the correct postions.

Front Legs(C) should be led bevel outside when finish turning.Install Hind legs(D)

need use Silicon Washer(②) to achieve stability bending inward as picture

shown when finish turning.

Note: The use of Gaskets are OPTIONAL and are especially useful to help

alleviate slight wobbleness. Some Legs may need more than one gasket

whilst some legs may not need any.

Place the Chair Base(B) as picture show on a clean, non-marring surface.

Lay Chair Backrest(A) and inner box aside.

Open the inner box and take out the Four Legs and hardwares.

Front Leg (C)

Chair Base (B)

Chair Backrest(A)

①

②

Hind Leg (D)

Chair Base (B)

Noble House Home Furnishings LLC

Page 4 OF 7