Installation Guide

Part I.
Before performing a leak test, be sure:
1. ) DO NOT press the Ignitor .
2. ) You are in a spacious outdoor area.
Connect the Propane Gas tank to the Regulator (14/19 ) and turn the Valve (22) on the unit to the “OFF”
position.
Brush soap and water mixture onto all connections.
Turn the gas supply on;if extra large bubbles form on any connection there may be a leak. If you smell
gas or a leak is discovered, IMMEDIATELY turn the gas valve off, disconnect Propane Gas tank.
Do not use the appliance until the leak is repaired
SAFETY INFORMATION - OPERATIONS
Inspect the Gas Hose (14) before use the Fire Table / Column.
If there are signs of wear or abrasion on the hose, you must replace the Gas Hose (14).And the Gas Hose
must be supplied directly by manufacturer.
Lava rocks could pop up and strike somebody’s face during the process of lighting this unit.
Stand away from the Fire Table / Column for the initial 20 minutes after igniting.
Observe flame colour and flame height when the
Fire Table/Column after being lit :
1. ) Flame color should be yellow / blue.
2. ) Flame height burns at 2 - 10 inches high.
Wait 10 minutes after extinguishing flame prior to replacing a lid (if applicable) or protective cover onto
the Fire Table / Column.
2inchesto10inches.