Installation Guide

Part H.
STEP 2
STEP1
2.
Remove the Electronic Ignitor Cap (16) on the electronic Ignitor (16) by unscrewing and slide the
Battery (B) into the battery slot (16).
Make sure the positive side of the Battery( B ) faces outwards.
Screw the Electronic Ignitor Cap (16) over the battery, tightly.
USER'S INSTRUCTIONS
Tabulated herebelow are the basic steps to help you light and use your Fire Table / Column.
3.
Subject to your preference, you may pour Lava Rocks over the Burer Ring. The Guard
MUST NOT BE BLOCKED. Refer to guidance below :
Note : Do not place more than 1/4 inch depth of lava rocks above the burner holes. Doing so will
suffocate the flame.
Note : Do not place more than 6KG of lava rocks above the burner holes. Doing so will suffocate the
flame.
STEP 3
1.
Check that the Control Knob (15) for the gas supply system is turned to the “OFF” position before
starting any assembly.