Use and Care Manual

Step4
Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, apply steady and even pressure down on the Table Top with the help of an
adult partner. Adjust the Legs Pre-installed Levellers until the Table is level with the
ground.
Adjust the levellers to the desired height to avoid wobbles.When the Table is level
proceed to tighten all Bolts at all joints.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This would cause the frame to warp.
If the Table is not stable it could lead to damage to the product.
Step 5
Your Table is ready for use.
This Table can only be used on a Flat Level Surface.