2018 User Manual ZCC RB4 FCC ID :2AR3JRRB4
Introduction Thank you for buying ZCC RB4! For support and help, please, e-mail at support@myremoto.com or call +7.495.929.7075.
Specification Please, see table for detailed specification of ZCC RB4. Table 1.
GIFT/ICT Yes Data Transfer Rate 1 Mbit/sec Common Mode Range 7 — 12 V Thermal Shutdown support Yes K-Line (ISO9141) Connection Yes K-Line connection with 1 KΩ master resistor Data transfer rate 38 Kbit/sec Data Storage Flash memory 16 Mb iNEMO Inertial Module (3D Accelerometer and 3D Gyroscope) Leaner acceleration sensing range Angular rate measurement range ±2/±4/±8/±16 g High-performance mode Embedded temperature sensor up to 1.
Frequency Band CAT M1 FDD2 CAT M1 FDD4 CAT M1 FDD12 CAT M1 FDD13 WiFi 2.4 G (802.11 n mode) BT Max power(dBm) 21.85 22.09 22.25 22.67 17 5 Distribution Kit The distribution Kit of ZCC RB4 components as follows: ‒ ‒ comprises the parts and ZCC RB4 main body Installation Kit. Installation To install ZCC RB4 onto your motor car, please, follow these instructions below.
WARNING! THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION WARNING! NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Contacts E-mail: info@myremoto.com tel. +7.495.929.7075 Mail Address: Ugreshskaya St.
