User's Manual
Table Of Contents
- Trade Marks
- Copyright statement
- FCC Radiation Exposure Statement
- R&TTE Compliance Statement
- Safety
- Restriction of use
- Intended use
- EU countries intended for use
- EU Countries not intended for use
- Potential restrictive use
- Declaration Of Conformity
- 1 Introduction
- 2 Wireless LAN basics
- 3 Series 1100 installation
- 3.1 Hardware installation
- 3.2 11 Mbps Wireless LAN ISA Card installation
- 3.3 11 Mbps Wireless LAN PC Card Windows 95 installation
- 3.4 11 Mbps Wireless LAN PC Card Windows 98 installation
- 3.5 11 Mbps Wireless LAN PC Card Windows NT4 installation
- 4 Connect‘
- 4.1 Appearances
- 4.2 Establishing a connection
- 4.3 LED indicator
- 5 Network protocols
- 6 Troubleshooting
- 6.1 Windows 95/98
- 6.2 Windows NT4
- 6.3 Connect‘
- 7 Technical Specifications 11 Mbps Wireless LAN PC Card
- 8 Software Installation
NoWiresNeeded
User manual 11 Mbps Wireless LAN PC Card Page 15 of 41
Some extra steps are required to complete the installation under
Windows 95/98:
6. When starting Windows 95/98, a window will appear,
indicating that new hardware has been found. The SCM
Plug & Play Swap Box will be installed automatically.
The SCM Swap Box is disabled by default. To enable it, you should
do the following:
7. Go to the Windows Control Panel and double-click on
PC Card (PCMCIA). Click <Next>, <Next> and <Finish> to
complete the installation.
The installation procedure of the 11 Mbps Wireless LAN ISA
Card is now completed. Depending on your operating system,
you should proceed to one of the following paragraphs for the
11 Mbps Wireless LAN PC Card installation.