Installation Guide

4
Option 2
1. You can also remove the adapters without adjustable pliers by taking advantage of the leverage effect of
the grb bar itself. The first step is to unscrew one end of the grab bar (see pic. 21).
2. Grab the grab bar and carefully turn it applying consistent pressure in order to remove the adapter still
attached to the grab bar and surface (see pic. 22).
3. After you have removed the first adapter, reattach the other side of the grab bar to the second adapter
still attached to the surface.
4. Grab the grab bar and carefully turn it in order to remove the adapter as described in step 2.
5. Remove residual adhesive from surface using a razor knife and wipe with acetone remover as needed. For
rough surfaces, a coarse brush can also be used. When using a coarse brush, please wear protective
goggles to protect your eyes (see pic. 23)
Caution!
Caution!Caution!
Caution! Use care not to scar the surface with the grips or razor knife when removing the adapter.
Safety Warning:
Safety Warning:Safety Warning:
Safety Warning:
- Follow instructions carefully to ensure proper performance as well as to reduce the chance of injury.
- If you have purchased the nie wieder bohren. adapter, be sure to check the stability of the wall prior to mounting. If the existing wall is
old or has any visible water damage or weakness, the performance of the grab bar could be affected negatively.
- When installed properly on a sturdy surface, the nie wieder bohren. system exceeds the ADA (Americans with Disabilities Act)
requirements for a weight capacity of 250lbs. However, grab bars are not designed to support a person’s total weight and rather to
provide for stability and assistance. Do not stand or sit on the grab bar!
- It is recommended to routinely check your grab bar in order to make sure it is properly secured and no looseness or wall damage noted.
- The GB00002-NDR adapter kit contains small parts which should be kept out of reach of CHILDREN, PETS and those NOT APPRISED in
the use of this product at all times in order to avoid injuries such as from swallowing or eye contact.
- Do not substitute any other adhesive for use with the nie wieder bohren. system. This is a professional grade adhesive which was
especially designed for this adapter.
- Dispose of adhesive tube directly into trash after use.
- The alcohol cleaning cloth should only be used for its intended purpose. It can only perform sufficiently if opened directly before use.
- When using cleaners and chemicals like acetone, please observe the manufacturer’s specific safety regulations.
- First Aid:
Skin: Avoid long term contact with the skin. Rinse with running water and soap. Apply replenishing cream. Change all contaminated
clothing.
Eyes: Avoid contact with the eyes as well as with other mucous membranes. Wash with plenty of water immediately and continue for
several minutes, holding eyelid open. Consult a doctor.
If ingested, Seek medical advice immediately and show this container or label and/or contact poison control
For further information call 800-961-5804 or go to
http://www.niewiederbohren.de/media/raw/Safety_Data_Sheet_nwb2011_en.pdf
for a copy of the MSDS (Material Safety Data Sheet)
21
2121
21
22
2222
22
23
2323
23