MSDS

MSDS-No.: 75816
V004.0
TEROSTAT MS 9380 WEISS DK310ML Page 2 of 4
Ingestion:
Seek medical advice immediately and show this container or label.
5. Fire fighting measures
Suitable extinguishing media:
All common extinguishing agents are suitable.
Extinguishing media which must not be used for safety reasons:
High pressure waterjet
Special protection equipment for firefighters:
Wear protective equipment.
Wear self-contained breathing apparatus.
Hazardous combustion products:
carbon oxides.
6. Accidental release measures
Personal precautions:
Wear protective equipment.
See advice in chapter 8
Environmental precautions:
Do not empty into drains / surface water / ground water.
Clean-up methods:
Remove mechanically.
Dispose of contaminated material as waste according to item 13.
7. Handling and storage
Storage:
Ensure good ventilation/extraction.
Store in a cool, dry place.
Temperatures between + 15 °C and + 25 °C
8. Exposure controls / personal protection
Components with specific control parameters for workplace:
none
Engineering controls:
Ensure good ventilation/extraction.
Respiratory protection:
Suitable breathing mask when there is inadequate ventilation.
Hand protection:
Chemical-resistant protective gloves (EN 374). Suitable materials for short-term contact or splashes (recommended: at least
protection index 2, corresponding to > 30 minutes permeation time as per EN 374): Polychloroprene (CR; >= 1 mm
thickness) or natural rubber (NR; >=1 mm thickness) Suitable materials for longer, direct contact (recommended: protection
index 6, corresponding to > 480 minutes permeation time as per EN 374): Polychloroprene (CR; >= 1 mm thickness) or
natural rubber (NR; >=1 mm thickness) This information is based on literature references and on information provided by
glove manufacturers, or is derived by analogy with similar substances. Please note that in practice the working life of
chemical-resistant protective gloves may be considerably shorter than the permeation time determined in accordance with EN
374 as a result of the many influencing factors (e.g. temperature). If signs of wear and tear are noticed then the gloves should
be replaced.