Basic Guide

fig. 9 fig. 10

Undo the two screws found left and right on the lower

part of the tumble dryer back (fig. 9). Lift the machine

and correctly place it over the stand, trying to position

first the stand against the rear brackets and then the

suction caps over the stand surface (fig. 10).

fig. 11

Fit the rear brackets to the machines back using the

previously removed screws (fig. 11).

fig. 12 fig. 13

The stands drawer, with a capacity of up to 35 kg, con-

tains two dividers; they may be taken out if you wish

(fig. 12). The drawer was designed with a special com-

partment inside where you can place a folding plastic

box, supplied, quite useful to store your washing laun-

dry (fig. 13).

fig. 14 fig. 15

The drawer slides on two metal runners and can easily

be pulled out to the full. Should you wish to remove the

drawer, you must pull it out completely (fig. 14) and act

on the two black plastic levers halfway through the

metal runners. Pull the right lever up and the left lever

down: the drawer will be uncoupled from the runners

and easily removed (fig. 15).

Warning! Do not place any solvent or flammable

substance into the drawer, as the fumes could be a

possible cause of fire.