Basic Guide

• 2 white long rubber feet to be used for the following

tumble dryer models:

• 6 rear metal brackets (4 for washing machine and 2 for

tumble dryer) ;

• 6 self-tapping screws (4.2 x 13 mm);

• 1 key to adjust the stands feet.

Important! Before starting the installation, adjust the

stand's feet in order to achieve a perfectly stable hori-

zontal position.

fig. 2

Proceed as follows (fig. 2):

• loosen the nuts using the key supplied with the

stand;

• adjust the feet to allow for an uneven floor;

• tighten up all check nuts.

fig. 3 fig. 4

Lay the machine on its left

side, making sure you do

not damage it. Remove the

front feet (fig. 3) and re-

place them with the rubber

ones.

Tighten the back feet (fig.

4).

Warning! If you install the stand under an energy

saver model Class A, you must not use the tumble

dryer immediately. Please wait 8 hours at least. For more

detailed information, read the appliance user manual

carefully.

fig. 5

fig. 6

fig. 7 fig. 8

After having removed the front brackets from the stand

(fig. 5), fit the rear brackets (fig. 6 and 7) to the stands

back, using the screws supplied (fig. 8).