Manual

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
[e-mail] ∞ www.nm-eng.com!
!
7. Install NM adapter onto end of shift lever with
set screws facing front to back. Tighten using
3mm Hex Key wrench. With shift lever fully
seated into adapter set screws should be almost
flush with adapter body.
8. Grease ball end and push-on cable.
9. Leave off shifter box cover, re-install exhaust
heat shield, exhaust system and tunnel brace.
10. Double check complete installation.
©2009 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
DOC. NM.668856 Rev. 04.01.10
!