Manual

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
[e-mail] ∞ www.nm-eng.com!
!
!
!
!
PARTS INCLUDED: TOOLS REQUIRED:
[1] SS Billet Adapter [1] Ratchet Wrench [1] 17mm Socket [1] 3mm Hex Key Wrench
[2] M6x10mm SS Set Screw [1] Jack [4] Jack Stands [1] Small Screwdriver or 90° poker
[1] 10mm Socket [1] Large Screwdriver
1. Park car on a flat and level surface capable of
supporting the vehicle’s weight on vehicle jack
and jack stands. Using the manufacturer
recommended lifting points, raise the vehicle
and support with jack stands under lifting
points. NEVER WORK ON A VEHICLE
SUPPORTED ONLY WITH A JACK!
2. Remove exhaust tunnel cross-brace, (4) 10MM
Hex Bolts.
3. Disconnect exhaust from downpipe at V band
clamp (17MM Hex). Spray WD-40 or equivalent
on rubber exhaust hangers to ease removal,
using large screwdriver pry off and remove
exhaust.
4. Remove forward tunnel heat shield. There are 3
tin nuts and 1 plastic nut on each side.
5. While pulling down on bottom shifter box cover
with your fingers, carefully pry outward locking
tab to unhook, do the same to the rest of the
tabs around shifter box.
6. Pull down on the cable while prying opposite
side with large screwdriver to disconnect from
shifter.
SHORT SHIFT ADAPTER – NM.668856
[R55] MINI Cooper, S & JCW Clubman 2008-up
[R56] MINI Cooper, S & JCW Hardtop 2007-up
[R57] MINI Cooper, S & JCW Convertible 2009-up