Manual

Screen 8B
PW/BOOST CONTROL DEC
This screen will decrease the importance of PW while increasing the importance of boost in 1% increments as
you press button 2. Decreasing the weight of boost is useful for quick spooling turbos or positive displacement
superchargers in EFI applications. (See Screen 8A)
Screen 9
POWER MODE
Set this screen to Boost
Screen 10A/B/C/D
POWER set points
Note Power Mode is used with MPG-MAX systems only
Nozzle Identifi cation Chart:
Nozzle Number Nozzle Size Nozzle Number Nozzle Size
1 60 ml/min 4 225 ml/min
2 100 ml/min 5 375 ml/min
3 175 ml/min 6 625 ml/min
Tuning Examples:
To properly tune the Stage 3 Controller you must fi rst fi nd your baseline Fuel Injector Pulse Width and Boost
Ratings.
PW/Boost Control
Decrease--------
Power Mode Boost
Change--------
Power Start 100
Increase--------
NO3 Prong To 12V Key-
On Power
Pump
Low Fluid LED
Injection Status LED
A
ir Flow
Throttle Plate
+12 Volt Key On
Engine Ground
Wire Connection
Boost Switch
Red
Red
20A Fuse
White
Blac
k
Blac
k
Yellow
Boost Line To Engine
Boost Source
Green
Red Wire To
COM Prong
Blac
k
Blac
k
To Battery Positive (+)
Level Switch
Red