installation User guide

2
For the Chevrolet pickups/SUV’s you will need to remove the dash bezel to install the
switch panel.
1. Set the parking brake.
2. Move the column shift lever (on Automatic transmission vehicles) into D1.
3. Pull the dash bezel from the corner and the bezel should pop loose, it is best to
remove the bezel completely for now.
4. Once the dash is removed you will need to drill a small hole (3/8” recommended) for
the wires to pass through, you can see the two small holes where the mounting tabs
go and recommended area to drill hole.
5. Place switch panel in the small compartment and push tabs through the bottom to
secure switch panel to the dash bezel.
6. Reinstall dash bezel.