Manual

4
ILLUSTRATION B
HITMAN WIRING
WIRING THE SOLENOIDS
1. Mount the master arming switch within easy
reach, and plain sight of the driver.
2. The system is furnished with a universal
wide- open throttle switch. This WOT micro-switch is designed to
work with the universal
mounting bracket. It’s maximum capacity is 10 AMPS and should only be used to
activate low amp
draw accessories or in conjunction with a relay.
3. Assemble the micro-switch on the
mounting bracket using the supplied bolts and nuts. The switch can be
mounted in several
different configurations, select the position your applica tion requires and tighten the bolts.
Do not
over- tighten; the plastic micro switch can be damaged.
4. The mounting bracket is made of easily
bendable material and may be formed to any configuration that will
allow it to place the WOT switch in
the proper location.
5. The activation arm on the micro-switch is
extra- long. This allows you to twist, bend, or cut it to aid in the
ease of installation. Attach an
18-ga. jumper wire from the remaining terminal “ACC” of the master arming
switch to one of the terminals
on the wide open throttle switch.
6. The best power source for the nitrous system
is the terminal on the back of the alternator labeled “BAT”.
The next best power source is
directly to the “Positive” post on the battery. Do not try to “Splice” into the
factory wiring harness for
a power supply, this will not have adequate amper age to operate the solenoids. If
desired a 40
amp fuse may be installed in this circuit.