Quick Start Guide

Check the thickness and type of base material before fastening. Follow your
specific jobsite instructions and building code requirements.
In fastening into steel substrate, the minimum thickness of substrate must
be 3/16".
WWW.NITROSET.COM
NTS8X Quick Start Guide
Always wear proper safety equipment including safety glasses, hard hats,
hearing protection, and gloves while operating the tool.
Required Safety & Protective Equipment
Adapter Usage Table
Minimum concrete thickness is three times the fastener penetration
(ie. 3" of concrete base material is a minimum requirement for 1"
penetration).
Check Before Fastening
The NITROSET® tool is for fastening into the following base materials only:
Concrete
Structural Steel
Never attempt to fasten into any material other than those listed above.
Acceptable Base Materials
Remember to read the NTS8X Tool Operation & Safety Manual for detailed
procedures of troubleshooting, tool assembly, disassembly and cleaning.
1
The universal nosepiece (NTS101-1S-C3-C) can use an adapter to
accommodate the different length pin or clip assemblies.
*Use NTS101-1-ST Nosepiece with A-Adapter (Red) for STT14.
Adapter
Requirement
No Adapter
Needed
With A-Adapter
(Red)
Types of Pin and Pin/Clip Assembly
CLAS532 CLSUPL532 PIN532NW STT14*
CLU222
CLS222S
CLR14-222
CLR38-222
CLT219
CLAS525
CLSUPL525
CLC38-222
CLC12-222
CLC34-222
CLC1E-222
CLR14222-BRT114
CLRHD14-525
PIN219
PIN219T
PIN222
PIN222W
PIN222SW