Instructions / Assembly

B. Remove the bulb from its box being careful not to touch the lens of the bulb. Install
the bulb by pressing the two bronze legs of the bulb into the ceramic socket in the
light housing as shown in FIG 3.
C. Be sure that the bulb is firmly pressed into the socket.
D. BE CAREFUL NOT TO BURN YOURSELF AS THE BULB GETS HOT QUICKLY AND SHOULD
BE TURNED OFF IMMEDIATELY UPON SUCCESSFUL TESTING. OPERATION OF THIS FIX-
TURE OUT OF WATER FOR ANY PROLONGED TIME WILL
DAMAGE THE UNIT AND VOID THE WARRANTY. Plug the light into a wall outlet. Turn switch
on. If light turns on, the test was successful. Unplug the unit. Move to step E. If light does not
turn on, unplug unit from wall and reinstall light bulb. Repeat test again. If it is still not working,
contact Smartpool customer service at [phone].
E. Carefully install the square diffuser/heat shield into the light box as shown in
figure 3A. Be sure that the glass has its textured (rough) side facing away
from the bulb.
F. Carefully replace the lens making sure that there is an even flat fit in
the light body.
G. Place the seal ring carefully over the lens making sure it is on
straight. Now turn in a clockwise direction until the ring begins to
tighten up. You may hear a clicking sound which is normal. This is a
safety feature designed to not allow the light seal to loosen up
or be removed without the key.
H. Continue to turn clockwise until the index mark on the seal ring is
even with the light body as shown in Figure 4. NOTE DO NOT
OVERTIGHTEN OR TURN BACK SEAL RING IN A COUNTER
CLOCKWISE FASHION AS THIS WILL CAUSE LEAKAGE!
I. Light is ready to install.
2007 NL100 Manual:Layout 1 1/16/07 12:41 PM Page 2