Manual

ManualsBrandsNitek ManualsHardwareVH856M

Installation and

Operation Manual

VH856

VH1656

VH856M

VH1656M

NITEK ®

Rev 040810

USA Office: Europe Office (Netherlands):

5410 Newport Drive • Rolling Meadows, IL 60008 De Schans 19-21 2a • 8231 KA Lelystad

Phone: (800) 528-4343 Phone: +31(0) 320-230005

Fax: (847) 259-1300 Fax: +31(0) 320-282186

Email: info@nitek.net Email: info@nitek.nl

Web: www.nitek.net Web: www.nitek.nl

Summary of content (4 pages)

PAGE 1
Installation and Operation Manual VH856 VH1656 VH856M VH1656M Rev 040810 NITEK USA Office: 5410 Newport Drive • Rolling Meadows, IL 60008 Phone: (800) 528-4343 Fax: (847) 259-1300 Email: info@nitek.net Web: www.nitek.net ® Europe Office (Netherlands): De Schans 19-21 2a • 8231 KA Lelystad Phone: +31(0) 320-230005 Fax: +31(0) 320-282186 Email: info@nitek.nl Web: www.nitek.
PAGE 2
Reduce risk of fire or electrical shock. Do not expose this product to rain or moisture. Installation UTP Video Receiver Hubs are designed to receive standard UTP video and output standard coax video. Step 1) Check the twisted pair for distance and continuity. Do this by shorting the pair of wires at one end and use an ohm meter to check the resistance at the other end. The chart below will give you the length of your wires for a measured loop resistance.
PAGE 3
Step 4) Remove the front panel of the receiver by pulling the knobs toward you. Inside locate the receiver unit to match the camera you are working on. Set the DIP switches for your camera distance as listed below. Use the setting closest to your actual cable length. If you have no video or a streak through your video your wire pair may be reversed. When finished replace the front panel and lock it in place by pushing the knobs in.
PAGE 4
Troubleshooting Problem Fix/Cause Video inverted or rolling and unstable. • Reverse the wires of the twister pair at either the transmitter or receiver. Problem Fix/Cause No video out at the receiver. • Check to make sure that there is video in at the transmit end. • Make sure that the pair of wires you are using is not open or shorted between the transmit and receiver points. • Check power to the receiver. Problem Fix/Cause Ghost image at the receiver.