Specifications

No.

1505982

HUGHES PROPRIETARY

Rev.

Sheet 6 of 28

Form E75a Hughes Network Systems, LLC

1. INTRODUCTION

1.1 PURPOSE/SCOPE/RESTRICTED USES

1.1.1 Purpose

This document defines the functional and performance requirements for the Low Noise amplifier (LNA) for the RF Equipment

used in a Ka-band Satellite Gateway.

1.1.2 Scope

This document shall be used as the contractual performance requirement source for the design, development, fabrication,

qualification, installation, and product acceptance activities pertaining to the procurement of the Low Noise amplifier.

Unless otherwise stated the technical requirements described in this document applies to both Ka-band LNA models:

1) LNA with a SMA connector shared by RF output and DC supply input, HNS part # 1505982-0001, and

2) LNA with an SMA connector for RF output and a separate connector for DC supply input a, HNS part # 1505982-0002.

1.1.3 Restricted uses

The product specified in this document must meet all safety, emissions, immunity, environmental requirements and all HNS

corporate requirements for the markets in which it is to be sold or installed.

1.2 REVISION HISTORY

Table 1-1: Revision History

Rev.

Description

Initial Release

Update to:

A. Delete R4-06 requirement for noise source deleted.

B. Table 5-1 the requirement for in-band Gain is reduced.

C. Table 5-1 added requirement for out-of-band Gain

D. Table 5-1 added requirement for Input IP3 out-of-band.

E. Section 5.2 modified Voltage Range changed to +10 to +15 VDC.

F. Section 5.2 modified power consumption.

G. Section 5.2, added Reverse Polarity Protection for the DC power supply.

H. Added 2

option: LNA with a separate power connector (1505982-0002)

Specs released. Same as revision 2.

Specs updated released to revision B

1. Added Outline drawing section 7.2

2. Relaxed VSWR specs R6-01

3. Updated IIP3 specs R5-010

4. Deleted optional requirement of section 6.4

5. Deleted section R7-08

6. Removed TBDs and TBRs

Typo correction in section 9.1 and 10.5.1. Deleted IEC61000-4-11 requirement in section 10.5.