Specifications

Niraxx Smart Headband System Specification
Product: Niraxx Smart Headband File Number: 20191210001
Model: Date: Dec 10, 2019
Page 6 of 7
The information contained in this document is PROPRIETARY to WEEL Technologies, LTD and shall not
be printed, copied or used in part or whole without WEEL’s written consent.
8. Pod Module Operation & Features
8.1 POWER OFF State
8.1.1 The Pod Module default state is POWER OFF. Under this state, all the peripherals and
functions for the system micro power consumption are closed.
8.2 POWER ON State
8.2.1 From the POWER OFF state, press and hold the module button for 3 seconds to power
on the system. Once POWER ON, the system will perform the following functions:
a) Initialize and configure firmware
b) Start Bluetooth
c) Check if internal hardware, Bluetooth and Battery power are in normal working
state or not. If working improperly, the system will enter into the WARNING state.
8.3 WAIT State
8.3.1 When the system powers on, it will automatically check if the system connects to App
and the headband is worn successfully or not. If the headband is connected and is
being worn, the system will enter into the HEADBAND STATUS UPDATE &
TREATMENT MANAGEMENT State or else it will enter into WAIT state and then
power off automatically in 2 minutes.
8.4 HEADBAND STATUS UPDATE & TREATMENT MANAGEMENT State
8.4.1 The system will enter into the HEADBAND STATUS UPDATE & TREATMENT
MANAGEMENT State and perform the following functions after it connects to App:
a) Update the headband status every 100ms.
b) Send the headband status to the App via the BLE service every 500ms.
c) Receive the command from the App.
d) Control IR LED to perform the treatment.
8.4.2 The system will keep treatment running even though Pod Module is out of BLE range
of the phone or the App is turned off during the treatment.
8.5 CHARGING State
8.5.1 The system will enter into CHARGING state when it connects with charge cable and
power off automatically if disconnect the charge cable.
8.5.2 In CHARGING state, the system still can be power on and perform treatments.
8.6 SYSTEM HARDWARE RESET State
8.6.1 When a system error occurs, please press and hold the module button for 7 seconds to
reset the system hardware (white LED will flash once and then power off).