Use and Care Manual

8
Illustration #1 Illustration #2
To Install Your Beverage cooler
- This Beverage cooler is designed for free standing or built-in (fully recessed) installation.
- Place your B e verage cooler on a solid and level floor that is strong enough to support it when
it is fully loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling
legs in and out to stabilize the cooler horizontally. If the legs are not properly adjusted, the
cooler may be unstable and result in excess noise or vibration.
- Locate the Bever age cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acry lic coating and heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also cause the cooler not
to perform properly.
- It is no t advisable to install this cool e r in moi st areas or direct l y adjacent to a kitchen sink, as
moisture could cause premature corrosion to the components of your new cooler.
- It is recommended you install the Beverage cooler in a place with temperatures above 60°F
(15°C) and below 90°F (32°C), and humidity is under 60%. If the ambient temperature is
above or below recommended temperatures, the performance of the cooler may be affected.
Placing your cooler in extremely cold or hot conditions may cause interior tempe ratures to
fluctuate, and the tempe rature range of 3ºC-18ºC (37ºF-65ºF) may not be reached.
- Connect the Beverage cooler to an exclusive, properly grounded, standard electrical supply
1 Gasket
2 Screw
3 Screw Driver
4 Handle