Use and Care Manual

8
Illustration #1 Illustration #2
To Install Your Wine Cooler
- This wine cooler is designed for free standing or built-in (ful l y recessed) installation.
- Place your wine cooler on a solid and level floor that is strong enough to support it when it is
fully loaded. This will ensure a vibratio n-free and noise-free operatio n. Adjust the leveling
legs in and out to stabilize the cooler horizontally. If the legs are not properly adjusted, the
cooler may be unstable and resul t in excess noise or vibration.
- Locate the wine c ooler away from direct sunligh t and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may aff e ct the ac rylic coating and heat source s may increase electrical
consumption. Extremely cold ambie nt temperatures may also cause the cooler not to perform
properly.
- It is no t advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as
moisture could cause premature corrosion to the components of your new cooler.
- It is recomm e nded you inst all the wine cooler in a place with temperatures above 60°F
(15°C) and b elow 90 °F (32°C), and humidi ty is under 60%. If the ambient temperature is
above or below recommended temperatures, the performance of the coole r may be affected.
Placing your cooler in extremely cold or hot conditions may cause interior temperatures to
1 Gasket
2 Screw
3 Screw Driver
4 Handle