Use and Care Manual

the shelves approximately 1/2 out of the rail compartment.

To Remove a Sliding Shelf

1. Remove all bottles from the shelf.

2. Pull the shelf out as far as it will go.

3. Adjust the lever on each side of the shelf, as shown below (UP on the left, DOWN on the right)

and at the same time, pull the shelf out completely.

CARE & MAINTENANCE

Cleaning Your Wine Cooler

IMPORTANT: Always unplug the cooler before cleaning or performing maintenance. Never use

harsh cleansers or scouring pads to clean any part of the cooler.

 Turn off the power, unplug the wine cooler, and remove all items including shelves.

 Wash the inside surfaces with warm water and baking soda solution. The solution should

be about 2 tablespoons of baking soda to a quart of water.

 Wash the shelves with a mild detergent solution.

 Wring excess water out of the sponge or cloth when cleaning the area near the controls,

or any electrical parts.

 Wash the outside cabinet with warm water and a mild liquid detergent. Rinse well and

wipe dry with a clean soft cloth. Do not use steel wool or steel brush to rub the stainless

steel, which will contaminate the stainless steel with steel particles and rusting may