INSTRUCTION MANUAL BUILT-IN WINE COOLER MODEL: NPKBTALL01/NPKBTALL02 Phone：+1(818)600-2502
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS 3 PRODUCT DIAGRAM 6 INSTALLATION INSTRUCTIONS 7 Before Using Your Wine Cooler 7 To Install Stainless Steel Handle 7 To Install Your Wine Cooler 8 OPERATION INSTRUCTIONS 10 Controls 10 Recommended Temperature Settings 11 Storage 12 Door Lock 12 Shelves 12 To Remove a Sliding Shelf 13 CARE & MAINTENANCE 13 Cleaning Your Wine Cooler 13 Power Failure 14 Vacation Time 14 Moving Your Wine Cooler 14 Energy Saving Tips 14 Charcoa
IMPORTANT SAFETY INSTRUCTIONS Your safety and the safety of others are very important. This wine cooler complies with the applicable safety requirements and is safe for daily use. However, basic safety precautions should always be followed when using an electrical appliance, to reduce the risk of fire, electric shock, and personal injury. Plug into its own individual electrical outlet with a voltage rating that matches the rating label on the cooler (115/120V AC only, 60Hz, 10A).
1.This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 2. Children should be supervised to ensure that they do not play with the appliance. 3.
Do not use this wine cooler for other than its intended purpose. For indoor, household use only. Move this wine cooler by 2 people. Failure to do so can result in injury. Place this wine cooler in a well-ventilated area with temperatures above 15°C (60°F) and below 32°C (90°F). To ensure proper ventilation for your wine cooler, the front of the cooler must be completely unobstructed. This wine cooler must be installed in an area away from wind, rain, water spray or drips.
PRODUCT DIAGRAM 1 2 7 3 4 5 6 1 Top Hinge 5 Exhaust Window 2 Control Panel 6 Leveling Legs 3 Shelves 7 Glass Door with Handle 4 Lock 6
INSTALLATION INSTRUCTIONS Before Using Your Wine Cooler Remove the exterior and interior packaging. Check to be sure you have all of the following parts: o 14 Shelves o 2 Keys o Stainless Steel Handle o Instruction Manual o 2 Extra Screws for Installing Handle IMPORTANT: Before connecting this wine cooler to a power source, let it stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
Illustration #1 Illustration #2 1 Gasket 2 Screw 3 Screw Driver 4 Handle To Install Your Wine Cooler - This wine cooler is designed for free standing or built-in (fully recessed) installation. - Place your wine cooler on a solid and level floor that is strong enough to support it when it is fully loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling legs in and out to stabilize the cooler horizontally.
fluctuate, and the temperature range of 5ºC-18ºC (40ºF-65ºF) may not be reached. Connect the wine cooler to an exclusive, properly grounded, standard electrical supply (115 V AC only, 60 Hz), in accordance with the National Electrical Code and local codes and ordinances. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized products service center. Warning: Improper use of the grounded plug can result in the risk of electrical shock.
OPERATION INSTRUCTIONS Controls After plugging the wine cooler into a wall outlet, the cooler would turn on automatically and the LCD screen would show the temperature inside of the cooler. After setting your desired serving temperature, allow the cooler to cool down for 3 to 4 hours before placing wine bottles in the wine cooler. Dual-Zone Press once to turn ON the cooler. Press and hold about 3 seconds to turn OFF the cooler.
Single Zone Temperature setting range：5-18ºC (40-65ºF) Press once to turn ON the cooler. Press and hold about 3 seconds to turn OFF the cooler. Adjusts the temperature in 1 degree increments or decrements Press to begin temperature adjustment and ascertain the current temperature. Toggles the temperature display between Celsius and Fahrenheit. Press once to turn the interior light ON or OFF. Light Control The light will automatical turns off 10 mins later for energy saving.
Wine Varietal °F °C Rose and Sparkling Wines 41°F-46ºF 5°C-8ºC Dry/White Wines 48°F-53ºF 9°C-12ºC Red Wines 59°F-65ºF 14°C-18ºC Storage This wine cooler is designed to store standard Bordeaux 750 ml wine bottles. Many bottles differ in size and dimensions. As such, the actual number of bottles you may be able to store may vary. Storing large and/or oddly shaped bottles (including champagne and sparkling wine bottles) will decrease the capacity of your wine cooler.
the shelves approximately 1/2 out of the rail compartment. To Remove a Sliding Shelf 1. Remove all bottles from the shelf. 2. Pull the shelf out as far as it will go. 3. Adjust the lever on each side of the shelf, as shown below (UP on the left, DOWN on the right) and at the same time, pull the shelf out completely. CARE & MAINTENANCE Cleaning Your Wine Cooler IMPORTANT: Always unplug the cooler before cleaning or performing maintenance.
occur. Power failure Most power failures are corrected within a few hours and should not affect the temperature of your wine cooler. If the power is off for an extended period of time, proper steps should be taken to protect your contents. Vacation Time Leave the wine cooler operating during vacations of less than three weeks. For periods longer than this, turn the wine cooler off and leave the door slightly ajar to prevent odor from building inside the wine cooler.
Charcoal filtration system Your wine is a living object that breathes through the cork of its bottle. In order to preserve the quality and taste of your fine wines, they must be stored at the ideal temperature and ambient conditions. Your wine cooler is equipped with an active charcoal filtration system to ensure air purity, cooling efficiency, and to maintain an odor free cabinet for the storage of your fine wines.
TROUBLESHOOTING GUIDE PROBLEM The wine cooler does not run. The wine cooler is not cold enough. The compressor turns on and off frequently. POSSIBLE CAUSE SOLUTION The wine cooler may not be plugged in, or plug may be loose. Ensure the wine cooler has been plugged in properly. The wine cooler is turned off. Press to turn on the cooler. House fuse blown or tripped circuit breaker. Check/replace fuse. Reset circuit breaker. External environment may require a higher setting. Set a colder setting.
PROBLEM The light does not work. POSSIBLE CAUSE SOLUTION Not plugged in. Plug the cooler in. The circuit breaker tripped or a blown fuse. Check the breaker and/or fuses. The light button is “OFF”. Vibrations. The cooler seems to make too much noise. The door will not close properly. Moisture build up on interior or exterior of the wine cooler. Error Code: E1-E2-E3-E4-E7-E8 Press to turn the light ON. The cooler is not leveled. Check to assure that the cooler is level.
Warranty Terms Warranty Period 1. Customers are entitled to replacement or free repair service in case of quality defect(s) found in the product within 15 days upon receipt of the product. 2. Customers are entitled to free repair service from NIPUS for any product proven defective in material or workmanship that results in product failure during normal consumer usage and conditions within the valid warranty period, which is 12 months counting from the date of selling.
