Use and Care Manual

Illustration #1 Illustration #2

To Install Your wine cooler

This wine cool e r i s designed for free standing or built-in (fully recesse d) installation.

Place your wine cooler on a solid and level floor that is strong enough to support it when it is

fully l oaded. This wil l ensure a vibration-free and noise-free operat ion. Adj ust the leveling

legs in and out to stabilize the cooler horizontally. If the legs are not prop e rly adjusted, the

cooler may be unstable and result in excess nois e or vibration.

Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator,

etc.). Direct sunli ght may affect the acryl ic coating and heat sources may increase el e ctrical

consumption. Extremely cold ambient temperatures may also cause the cooler not to perform

properly.

- It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as

moisture could cause premature corrosion to the components of your new cooler.

- It is recommended you install the wine cooler in a place with temperatures above 6 0°F

(15°C) and below 90°F (32°C), and humidity is under 60%. If the ambient temperature is

above or below recommended temperatures, the perform ance of the cooler may be affected.

Placing your cooler in extremely cold or hot conditions may ca use interior temperatures to

1 Gasket

2 Screw

3 Screw Driver

4 Handle