Instruction Owner's manual

20
PS-270とモニターLVM-89Wを6Pケーブル(VC-450) とBNCケーブルで接続します。
Connect the MONITOR OUT connector of PS-270 to the MONI IF connector of the monitor with the supplied
6-pin cable (VC-450) and connect the RET connector to the CMP IN connector with a BNC cable.
カメラのアクセサリーシューの止まる位置までスライドさせます。
シューから抜けないようにシュー固定ねじで固定します。
角度調整固定ねじを緩めてモニターの見やすい位置が決まった後、再度固定ねじを締めます。
Slide the monitor to the stop position of the accessory shoe of PMW-EX3.
Tighten the Slide-Shoe Lock Knob to fix the monitor.
Loosen the Angle Adjustment Knob and
adjust the angle of the monitor so that the monitor can be watched easily, then tighten the knob again.
monitor
PS-270
4
5
Angle Adjustment Knob
Slide-Shoe Lock Knob
Slide-Shoe
Accessory Shoe
MENU
-
+
F
R
ONT T
AL
L
Y
REAR
T
ALL
Y
OFF L H
OFF L H
REAKING 16:9 MARKER
R
GB CO
L
OR INPUT
4:3
MONO
HD/Y
HD/B-Y
HD/R-Y
CMP IN
CMP OUT
TALLY IN
MONI IF
DC 12V IN
MONITOR OUT
(6-pin)
MONI IF
NIPROS PS−570
System Connection
RET
(BNC)
LVM-89W
CMP IN
supplied 6-pin cable
(VC-450)
BNC cable
front panel
connector