Owner manual

HDM-3000 各部名称と働き
7
HDM-3000
背面パネル
Rear panel
DC IN 12V ( DC 12V power supply input ) connector (XLR 4-pin)
Fan
Turns on when the power is supplied.
電源 ON 回転
Used for connection to the AC adaptor supplied.
付属の AC(DC 12V 電源)を接続します
PARALLEL REMOTE ( remote signal input ) connector (8-pin, RJ-45)
Used for the remote control: e.g. for TALLY signal input, INPUT signal selection and
Preset Function operation.
The pin assign, default setting is as the table shows.
The control signal is to short-circuit each pin with PIN 5.
ル - 例ば, ー信号入力, 入力切替, のON/OFF 等使用
ピンアサインはデフォルトではのようになています
コントロールピンと5とのショートです。
PIN 1 [R TALLY]
PIN 2 [G TALLY]
PIN 3 [B TALLY]
PIN 4 [MARKER]
PIN 5 [GROUND]
PIN 6 [INPUT 1]
PIN 7 [INPUT 2]
PIN 8 [ASPECT]
Pin Assign
PIN 1 [レドタ
PIN 2 グリーンタリー
PIN 3 [ブルーリー
PIN 4 [マーカー
PIN 5 [GROUND]
PIN 6 [INPUT 1]
PIN 7 [INPUT 2]
PIN 8 [アスペク
ピンアサイ