Manual

HDF-700V
05
HD View Finder HDF-700V
Front panel
VOLUME / PUSH SELECT switch /チル選択
INPUT select switch 入力切替
ZEBRA indication on/off switch 表示ON/OFF
MARKER select switch ー選択
By rotating the switch adjust the audio volume level of the monitor speaker (when the headphone is
disconnected) or the headphone level connected to the jack( ).
By pressing this switch select the audio channel, CH 1&2→3&4→1→2→3→4→5→6→7→8→ in
sequence, to monitor by the monitor speaker or the headphone.
Selects a input signal by pressing in sequence. The LED indicator on the INPUT switch lights up,
when the (SDI) RET IN signal is selected by operating the zoom remote controller.
Switches the ZEBRA indication, on(LED on) or off.
The level adjustment of the ZEBRA indication and the ZEBRA/FILL changeover are enable on the menu.
( See page 29 )
Selects the MARKER in sequence. The user setting for the
marker is enable on the menu.( See page 29 )
背面ーす音量を調整
(ボ)を順次押ーす信号(モカーはヘ信号)が切替え
( CH 1&2→3&4→1→2→3→4→5→6→7→8→ の順替わ)
INPUT 切替入力映像信号をSDI(HD/SD) IN 1[SDI-MAIN]→ RET IN [SDI-RETURN]
→analog (HD) component [COMPONENT]→ analog (HD) component [CAMERA]の順替わ
信号(RET IN)に の操作で切 INPUT 切替LEDが点灯
表示 ON/OFF 切替
出現ベル調整, ZEBRA/FILLの切替は、で設定(ページ29 参照)
カー表示 順にーザー設定が
(ペジ29 参照)
[SDI-MAIN] SDI [ SDI(HD/SD) IN 1 ]
[SDI-RETURN] SDI [ SDI(HD/SD) RET IN ]
[COMPONENT] HD component(analog) [ ANALOG Y/P
B/PR ]
Indication on the screen
RETURN
MAIN
LED
Input signal [ Input connector ]
→ 16:9
  16:9 / +(center marker)
4:3
4:3 / +
16:9 / 4:3
  16:9 / 4:3 / +
CROSS HATCH(LARGE)
  USER setting
  OFF( LED lights off )
POWER Indicator 電源表示LED
Lights up when the POWER switch is turned on and the power is supplied to the DC IN connector.
POWER が ON 点灯
(analog HD component)
[CAMERA] VF signals [ I/F (HD D-sub 15-pin) ]
力信号の表示 入力信号 [ 入 ]