Instruction Owner manual

LVM-89W底部の1/4インチ固定ネジ穴にユニバーサルヘッドをモニター固定ネジで固定します。

Fix the supplied universal head to the screw hole on the bottom surface of LVM-89W with the Monitor

Lock Screw.

Bottom Panel

Monitor Lock Screw

Universal head

カメラのアクセサリーシューの止まる位置までスライドさせます。シューから抜けないようにシュー固定ねじで固定します。

角度調整固定ねじを緩めてモニターの見やすい位置が決まった後、再度固定ねじを締めます。

Slide the universal head with LVM-89W into the accessory shoe of the camcorder untill the slide-shoe

stops in place. Tighten the Slide-Shoe Lock Knob to ﬁx the universal head with the accessory shoe.

Loosen the Angle Adjustment Knob and adjust the angle of VF-89W so that the monitor can be watched

well, then tighten the knob again.

Angle Adjustment Knob

Slide-Shoe Lock Knob

Slide-Shoe

2-2

To mount LVM-89W to the camera with the 1/4 inch screw hole(female) install the 1/4 inch male-male

screw adaptor to the bottom of the universal head and screw up to the screw hole of the camera.

Male-male

Screw

Adaptor

Male-male

Screw

Adaptor

1/4インチネジ穴タイプのカメラの場合は、ユニバーサルヘッドの下にオス-オスネジアダプタを取り付けて使用します。

Accessory Shoe

ONT T

REAR

ALL

OFF L H

REAKING 16:9 MARKER

GB CO

OR INPUT

4:3

MONO

FRONT TALLY

REAR

TAL

OFF L H

REAKING 16:9 MARKER

GB CO

LOR INPUT

4:3

MONO

LVM-89Wモニターの取り付け

Fix the monitor LVM-89W

Multi-core Studio System NIPROS/V26