Use and Care Manual

10 1-877-646-5288
Assembling the Nutri Ninja
®
2-in-1 Processor Bowl
USING THE 4 BLADE ASSEMBLY
IMPORTANT: It is recommended to pulse until the
ingredients are mixed unless recipe instructions state
otherwise. If the unit is run continuously for more than
30 seconds, let the Power Pod rest for 1 minute before
using again.
CAUTION: Blades are sharp! Use extreme caution
when handling the blades. Always hold them by the
shaft.
IMPORTANT: Never run the appliance empty.
CAUTION: 4 Blade Assembly is removable and not
locked in place. If pouring with the lid removed, always
remove the 4 Blade Assembly first. If using pour spout,
make sure the lid is secure on the jar by firmly pressing
on the thumb tab.
Fig. 5 Fig. 6 Fig. 7
1 Place the Nutri Ninja
®
2-in-1 Processor Bowl on a
clean, dry, level surface.
2 Place the 4 Blade Assembly over the spindle pin inside
the Processor Bowl. (Fig. 5)
3 Place ingredients in the Processor Bowl.
NOTE: For best results add wet ingredients first and
then add the dry ingredients.
4 Place the Geared Lid onto the top of the Processor Bowl
making sure the lid is securely in place. (Fig. 6)
5 Plug the power cord into an electrical outlet and place
the Nutri Ninja
®
2-in-1 Power Pod on top of the Geared
Lid. Pulse until all ingredients are well mixed.
(Fig. 7, Fig. 8)
6 Once processing is completed and the blades have
stopped spinning, remove the Nutri Ninja
®
2-in-1 Power
Pod and the Geared Lid. Remove the 4 Blade Assembly.
Fig. 8
WARNING: DO NOT try to assemble or operate the Power Pod,
Geared Lid and blades together outside of the containers.
CAUTION: 4 Blade Assembly is not locked in place. If using
the pour spout, make sure your thumb is firmly pressed
down on the thumb tab of the lid to secure the lid.
CAUTION: 4 Blade Assembly is not locked in place. If
pouring with the lid removed, ALWAYS remove the blade
assembly first.
Forbestresults,useshort“PULSES”bypushingdownonthebuttonin
short, 1 second bursts until desired consistency is achieved.