Instructions

AIR FRY
REHEAT
W
O
O
D
F
I
R
E
F
L
A
V
O
U
R
3
ninjakitchen.co.uk
4
ninjakitchen.co.uk
HANDLE INSTALLATION
1 Ensure the correct handle is being used on the left and right side. (Refer to Fig. A and note that the
handles have L and R stickers on the underside). A Hex key is taped onto the left handle (see Fig. A).
2 Place unit at edge of table (Fig. B) OR with lid still taped down, carefully place grill upside down by
holding the sides of the unit and the lid down. If tape has been removed, remove all accessories from the
grill and holding the sides of the unit and the lid down, place grill on top of top pulp tray piece to protect
unit (Fig. C).
3 Align each handle with tabs on base, then push up to set each handle in place (Fig. D). Use included Hex
key to tighten pre-assembled screws (2x) on each handle (Fig. E).
EXTENSION CORD
1
If using an extension cord, ensure it is suitable for use outdoors with outdoor appliances. Using
the incorrect cord could lead to the cord overheating, melting and/or a drop in voltage. A drop in
voltage can increase preheat times and impact cooking performance and/or cook times.
BEFORE FIRST USE - CONTINUED
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E
POWERING THE GRILL
1 Plug the RCD into electrical socket. Switch socket on.
2 Press RESET button on the RCD. The circle above
the RESET button should be illuminated orange. If
this isn’t the case, try a dierent socket. Note: It may
be dicult to see the orange if in direct sunlight.
3 Press the TEST button on the RCD. The circle should
now show black. This means the RCD is functioning
correctly. If pressing the TEST button does not
change the circle to black then contact customer
services.
4 After establishing if the RCD is functioning correctly
once again press RESET. The orange illumination
should re-appear. The unit can now be switched on.
NOTE: RCD Light;
ORANGE = RCD is ON ; BLACK = RCD is OFF
5 Press the on/o switch on the back of the control
panel. Switch is on when the side with the line is
pressed down.
6 Now turn the dial on the front of the control panel
and turn it to the desired function. The display
should illuminate to reveal times or temps. The grill is
now ready to use.
NOTE: The RESET button on the RCD will need
to be pressed every time the unit is unplugged or
the socket switched o.
EXTENSION CORD
If using an extension cord, ensure it is suitable for
use outdoors with outdoor appliances. Using the
incorrect cord could lead to the cord overheating,
melting and/or a drop in voltage. A drop in voltage
can increase preheat times and impact cooking
performance and/or cook times.
REMOVABLE SMOKE BOX
The smoke box comes fully installed in the unit and
is located on the right side of the lid. Always ensure
the removable smoke box is inserted into place
before adding pellets. Review all warnings before
proceeding.
Installing the smoke box:
To install, hold the smoke box lid open with one
hand and insert the removable smoke box so it
sits into place.
Adding Ninja Woodfire Pellets:
Fill the pellet scoop to the top and level o to
avoid spilling. While holding the smoke box lid
open, pour pellets into the smoke box until filled
to the top, then close the smoke box lid. Ensure
the lid is properly closed before cooking.
Use only Ninja Woodfire Pellets for best results,
performance and flavour.
Removing the smoke box and cleaning:
To avoid burns, allow pellets to completely burn
and smoke box to cool completely, then remove
smoke box and safely discard all contents.
BEFORE FIRST USE - CONTINUED