User manual

12
1-877-646-5288
13ninjakitchen.com
2 Ensure the adapter is in the REMOVE position
before installing. Then place the adapter over
the brew basket and push down firmly so it is
fully seated.
3 Slide the Ninja Pod Adapter handle into the
LOCK position.
4 Lift the Ninja Pod Adapter handle to reveal
the pod holder. Place a new pod in the
holder.
NOTE: DO NOT remove the top of the K-Cup
Pod.
HIGH-ALTITUDE BREWING: Before closing
the Ninja Pod Adapter handle to start a brew,
Using your fingers, carefully apply pressure
on the K-Cup Pod until the bottom of the
K-Cup Pod is punctured by the exit needle,
and the pod is fully seated in the pod holder.
This releases excessive gas built up from the
high altitude and prevents pod blowout.
NOTE: Make sure the brew basket is clean
and free of any filters before inserting the
Ninja® Pod Adapter.
NOTE: Reusable K-Cup Coee Filters are
not compatible with the Ninja Pod Adapter.
If using ground coee, use the grounds
mode with a paper or permanent filter (sold
separately) to brew a single-serve size.
5 Press the handle down firmly to pierce the
pod, and ensure that it is completely closed.
There will be an audible click and some
resistance when closing the handle as the
needles puncture the pod.
CLASSIC BREW & RICH BREW
1 Use the Multi-Serve dial to select the brew
size. Place the empty vessel under the brew
basket.
2 Press the BREW STYLE button to choose
either Classic Brew or Rich Brew.
3 Press the START BREW button on the dial
to start the brew. To cancel the brew at any
time, press the START BREW button on the
dial again or press the Power button.
4 The brewer will beep to signal the brew has
started. The progress bar above the
dial will illuminate to indicate the status
of the brew. When the brew is finished,
the machine will beep again and End will
appear on the display.
NOTE: Rich Brew will use slightly less water
and yield slightly less brewed coee than
Classic Brew. See Approximate Brew Volume
chart for additional information.
BREW STYLES
NOTE: If making a single cup, lower the
Single-Serve Cup Platform and set your
vessel in the center of it to help prevent
splashing. This applies to all brew styles.
OVER ICE BREW
1 Fill your desired vessel to the top with ice
cubes and place the vessel below the brew
basket. Use the Multi-Serve dial to select the
brew size.
2 Press the BREW STYLE button to choose
Over Ice Brew.
3 Press the START BREW button on the dial
to start the brew. To cancel the brew at any
time, press the START BREW button on the
dial again or press the Power button.
4 The brewer will beep to signal the brew has
started. The progress bar above the dial will
illuminate to indicate the status of the brew.
When the brew is finished, the machine
will beep again and End will appear on the
display.
NOTE: DO NOT use any glassware except the
provided Ninja glass carafe, which is safe to
use due to its specialized glass material.
NOTE: DO NOT add ice to the water
reservoir.
NOTE: The brewing cycle will begin, then
pause for a short period before resuming. This
process is used to evenly saturate the coee
grounds. This applies to all brew styles.
NOTE: Over Ice brew is designed to produce
a concentrated brew into a vessel filled with
ice. It is normal for some ice in the vessel
to melt as the coee is brewed, and this
will produce a cold beverage with the ideal
strength and flavor.
USING THE NINJA® DUALBREW COFFEE MAKER
CONT.
REMOVE
LOCK