User manual

CLEANING & MAINTENANCE
CLEANING THE NINJA POD ADAPTER
Open the handle to reveal the needles and pod
holder and hand-wash with warm, soapy water.
Take care when cleaning around the needles.
Then, close the handle and slide it back into the
REMOVE position before reinstalling.
CLEANING THE BREW BASKET
If brewing grounds, allow the brewer to cool,
then remove the brew basket by pinching the
handle and lifting straight up. If using a paper
filter, discard the filter by dumping the brew
basket upside down into a waste-bin. If brewing
pods, first remove the Ninja Pod Adapter, then
remove and wash the brew basket.
CLEANING & DESCALING YOUR BREWING
SYSTEM
Your Ninja DualBrew coee maker oers three
modes to choose from, Grounds, Pods, and Hot
Water. Each mode that you use will eventually need
to be cleaned with a clean cycle.
The clean cycle is used for descaling the brewer
when calcium scale buildup is aecting the
performance of the brewer and/or the flavor of
your coee. The Intelligent Clean Cycle Indicator
will automatically illuminate orange when a
cleaning cycle is recommended for your brewer.
If the indicator is ignored, your brewer may stop
mid-brew and display “CLn,” indicating it needs
immediate cleaning on the current mode.
CLEANING AFTER A BREW
1 After the brewer has cooled, remove the brew
basket. If using pods, remove the Ninja Pod
Adapter and brew basket. Wash the used parts
thoroughly with soap and warm water.
2 Wash the carafe and brew-through lid with soap
and warm water. Use a bottle brush or cloth to
wash the inside of the carafe. DO NOT use a wire
brush.
CLEANING THE WATER RESERVOIR
Empty the reservoir and hand-wash or place in
dishwasher. For a better clean, we recommend
placing it in the bottom rack of the dishwasher
standing upright with the opening facing
downward. We recommend doing this weekly.
CLEANING THE CARAFE
We recommend cleaning your carafe after each use
with warm, soapy water.
To clean the carafe more thoroughly, we
recommend using a soft foam brush. DO NOT use a
wire brush.
CLEANING THE SLIDING LID
Open the hinged hood on top of the brewer by
pulling up on the left side. Once opened, slide
the sliding lid out of the back of the brewer to
remove it. Hand-wash the sliding lid with warm,
soapy water. Slide the sliding lid back into its
tracks and close the hinged hood.
NOTE: For best results, we recommend
rinsing the reservoir after brewing and
refilling with fresh water for the next brew.
NOTE: The clean cycle takes approximately
75 minutes.
NOTE: DO NOT place the Ninja Pod Adapter
in the dishwasher.
NOTE: DO NOT place the sliding lid in the
dishwasher.
USING THE NINJA® DUALBREW COFFEE MAKER
CONT.
Volume
2 oz.
4 oz.
6 oz.
8 oz.
10 oz.
12 oz.
14 oz.
16 oz.
18 oz.
20 oz.
22 oz.
24 oz.
28 oz.
32 oz.
40 oz.
50 oz.
60 oz.
DISPENSING HOT WATER
The Ninja DualBrew Coee Maker has a
separate water line completely independent of
the line used for brewing coee. This ensures
you get clean water every time with no coee
cross-contamination.
1 To switch to Hot Water Mode, turn the dial on
the left side of the brewer to the water droplet
icon. You should notice a change on the
control panel.
2 Use the Multi-Serve Dial to choose one of
17 sizes between 2 oz. and 60 oz.
3 Press START BREW on the dial to start the
brew.
Not all functions are available
on all models.
NOTE: The water will cool down once
dispensed into vessel.
NOTE: When dispensing hot water, use a
vessel that is suitable for high temperatures.
NOTE: If the display is flashing the water
droplet icon, make sure the dial is turned
completely to one side.
16
1-877-646-5288
17ninjakitchen.com