Use and Care Manual

14 15ninjakitchen.com
VACUUM BLENDING WITH THE
SINGLE-SERVE FRESHVAC™ CUP - CONT�
IMPORTANT: Review all warnings
on pages 4-7 before proceeding.
10 Place the unplugged motor base
on a clean, dry, level surface such
as a countertop or table. Press
downward on the motor base to
adhere the suction cups to the
work surface. Plug the motor base
into a wall outlet.
12
If using a pre-set program, select
the program that best suits your
recipe. The pre-set feature will
automatically stop the unit at the
end of the program. To pause
the unit at any time, press the
currently active program a
second time. Reference page 11
for program descriptions.
11
Turn the Single-Serve FreshVac Cup
upside down and install onto the
motor base. Align the tabs on the
cup with the slots on the base, then
twist until it clicks into place. When
the unit is connected to power and
the cup is correctly locked onto the
motor base, press the Power symbol
to turn unit on.
13
When blending is complete, rotate
cup counterclockwise to remove
from motor base and place cup
on a level surface. Pressure must
be released before opening the
cup. The FreshVac™ Cup may be
stored in the refrigerator with the
spout lid for later use. DO NOT
store contents in the cup with the
Pro Exactor Blades® Assembly
attached. See page 16 for more
information.
15 Close the Flip & Seal Lid, pressing it
until it clicks into place.
16 Turn cup over so blade assembly
is on top. Rotate blade assembly
counterclockwise to remove. To
take your blended contents on the
go, place the spout lid on cup and
turn clockwise to seal.
17
Unplug the unit when finished.
To lift the motor base, place your
hands underneath both sides of
it and gently pull the unit up and
toward you. Refer to page 18 for
storing instructions.
14
Open the Flip & Seal Lid by pressing
the tab and lifting. To release the
vacuum seal, gently lift the FreshVac
Tab. Air will enter the cup, making it
easy to remove the blade assembly.