User's Manual

2
11
PARTS DESCRIPTION
(6) (1)
(2)
(3)
(4)
(5)
CH
MHz
A A B B
,
AF
MHz
AA BB
,
AF
a b c
d
e
f
g
( LCD Display )
(8) (9) (10) (11) (12)(12) (7)
3. Parts Description
3.1 Receiver
(1) Power Switch
(2) GP :
Group set button and GP / CH adjust
(UP)
(3) CH :
Channel set button and GP / CH adjust
(DOWN)
(4) GP LED indicator:
press GP button, it will light.
(5) CH LED indicator:
press CH button, it will light.
(6) LCD Display :
a. RF-A reception
b. RF-B reception
c. RF signal strength indicator
d. GP number
e. CH number
f. AF signal strength indicator
g. Frequency
(7) Antenna B
(8) AF unbalanced output :
phone jack
(9) AF balanced output :
XLR jack, balanced AF signal
output sensitivity is same as
dynamic microphone.
(10) DC Power Source Input Jack :
Connect AC / DC power supply
(11) Antenna A
(12) Mounting Rack
( Front Panel )
( Rear Panel )
( Picture for reference only )
USER'S GUIDE
6.2 Handheld Microphone
1. Open battery cover then insert battery ( pay attention to the positive and negative
pole). Close battery cover .
2. Turn on power switch (5), LCD will show group and channel set at last using time.
3. Group adjust: Press GP button (3) for about 3 seconds, GP number on LCD will
flash; release GP button (3), now GP button changes to UP function and CH button
(4) changes to DOWN function, press GP button to move GP UP or CH button to
move GP down.
4. Channel adjust: Press CH button (4) for about 3 seconds, CH number on LCD will
flash; release CH button (4), press GP button to move CH UP or CH button to move
CH down.
5. After adjusting Group or Channel, release all buttons, group or channel will flash
about 3 seconds and then stop, frequency will be locked and saved.
6. Adjust microphone's GP and CH (according to above procedure 3,4,5) to make the
frequency same as receiver.
7. After 30 seconds if no buttons are pressed, LCD will display battery power. Press
GP button or CH button, LCD will show GP number and CH number.
Note: If microphone LCD shows "LO", it means battery power will be exhausted.
Please exchange new battery. In the meanwhile, microphone will still work
normally for about 3 minutes. After 3 minutes if battery is not replaced,
microphone will stop working.
8. Take out battery if microphone is not going to be used for a long period of time.
interfere each other.
Users are suggested to use these frequencies firstly.
Choose other frequencies if more frequencies are needed.