WIRELESS MICROPHONE SYSTEM USER'S MANUAL
TROUBLE SHOOTING 8. Trouble-shooting CONTENTS Problem Solution No sound Check receiver and microphone power. Make sure transmitter and receiver frequency is same. Check if amplifier or other equipment's power is on. Check if the connection between receiver and mixer or amplifier is proper. Check microphone battery power. Check receiver antennas connection. Check if receiver is too close to metal parts or there is barrier between transmitter and receiver.
IMPORTANT SAFEGUARDS CONNECTION 7. Connection 1. Introduction Use 6.3mm unbalanced signal cable or 3 pin XLR balanced signal cable to connect receiver AF Output to MIC-IN jack on mixer or amplifier.(Refer to following illustration) Before installation please make sure receiver frequency is same as transmitter frequency.
PARTS DESCRIPTION USER'S GUIDE 3. Parts Description 3.1 Receiver (1) Power Switch (2) GP : Group set button and GP / CH adjust (UP) (3) CH : Channel set button and GP / CH adjust (DOWN) (4) GP LED indicator: press GP button, it will light. (5) CH LED indicator: press CH button, it will light. (6) LCD Display : a. RF-A reception b. RF-B reception c. RF signal strength indicator d. GP number e. CH number f. AF signal strength indicator g.
USER'S GUIDE 6. User's Guide 6.1 Receiver 1. Install attached two BNC antennas on the antenna jack at the rear panel of the receiver. Incline antennas outwards 45 degree to get the best reception. 2. To get the best reception, install receiver at least 1 metre above the ground. Keep transmitter at least 1 meter from receiver antennas and far away from interferential sources. 3. Use attached mounting rack to install receiver on EIA standard rack. 4.
4 740.270 740.990 741.710 742.430 743.150 743.870 744.590 745.310 746.030 746.750 747.470 748.190 748.910 749.630 750.350 751.220 740.315 741.035 741.755 742.475 743.195 743.915 744.635 745.355 746.075 746.795 747.515 748.235 748.955 749.675 750.395 751.290 740.360 741.080 741.800 742.520 743.240 743.960 744.680 745.400 746.120 746.840 747.560 748.280 749.000 749.720 750.440 751.360 740.405 741.125 741.845 742.565 743.285 744.005 744.725 745.445 746.165 746.885 747.605 748.325 749.045 749.765 750.485 751.
8 796 . 250 796 . 900 798 . 200 799 . 450 8 00 . 750 802 . 650 803 . 300 804 . 600 805 . 900 807 . 150 808 . 450 809 . 700 811 . 000 811 . 650 813 . 200 814 . 550 795 . 700 797 . 000 798 . 250 800 . 100 800 . 850 802 . 100 803 . 400 804 . 650 805 . 950 807 . 250 808 . 500 809 . 800 811 . 100 812 . 250 813 . 300 814 . 600 795 . 800 797 . 550 798 . 350 799 . 650 800 . 900 802 . 200 803 . 450 804 .7 50 806 . 050 807 . 300 808 . 600 809 . 900 811 . 150 812 . 300 813 . 350 814 . 700 795 . 850 795 . 150 798 .
6 853.650 862.900 859.100 863.400 854.050 861.300 851.350 860.650 862.800 859.050 852.000 852.200 853.600 862.450 861.250 857.700 851.250 854.950 860.500 855.450 857.350 861.900 858.800 862.650 853.900 854.200 856.200 856.300 854.300 859.850 852.350 856.400 852.550 855.300 860.100 860.300 860.600 863.700 860.200 863.000 852.750 855.750 863.450 861.350 859.700 855.350 860.000 855.100 852.300 857.750 852.800 861.800 862.750 856.750 852.500 857.050 852.250 862.500 853.500 860.800 862.050 853.700 853.200 855.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.