Users Manual

Users Have a Responsibility to Place or Install Safety
1
2 3
The speakers that are placed in the holder can be either wall or
ceiling type, using screws to be placed inside of the speakers in
the back is optional.
2
Then use the appropriate hardware and tools (not supplied)
are properly fixed to the bracket wall/ceiling.
3
Place the speakers to the bracket using the screws and
washers according to the speaker.
1
Mark the mounting bracket as a template with the regional
location of the hole slots.
INSTALLATION
Woofer
Fixed to the wall or ceiling
Mounting bracket
Tweeter
Bracket screws
Use wire on the back of the speaker in the output tab of the
amplifier (or amplifiers of radio). The speaker wire is on one side
red and on the other one black. Connect to the red side of the
amplifier and speakers (+) tab. Connect one end of the black side
(-) in the other tab. Connect each speaker to make sure that is
not (+,-) inverted polarity. If the polarity of the speakers is
reversed, the sound will be unnatural and will play without bass.
Connection
Stereo Connection
R
L
L+
L-
GND
R-
R+
LOOP
SUB
+
-
ON
SPEAKER
AUXIN
TRE
BASS
VOL
ON
AUTO
-12 +12 -12 +12
0
10
OFF
AC100-240V
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
1
5
2
Loop Output
4
Sub Output
RCA Input
6
Speaker Output
Aux Input
3
Balance Input
7
LED Indicator
9
8
Treble Adjustment
Bass Adjustment
10
Volume Control
11
Power Switch
12
AC Power Cord
speaker
PACKING LIST
US
E
R
MANU
A
L
user manual
1
2
3
4
5
7
6
9
8
10
11
12
+
-
0
R
L
L+
L-
GND
R-
R+
LOOP
SUB
ON
SPEAKER
AUXIN
TRE
BASS
VOL
ON
AUTO
-12 +12 -12 +12
10
OFF
AC100-240V
WARNIN G
RISK OF ELECTRIC SHOCK
DO NOT OPEN
SAFETY INSTRUCTIONS
When the speakers are installed in the wall, ensure the wall
structure is reliable and that the speakers are firmly
attached.
Install the speaker in a location that can structurally support
the weight of the speaker and its mounting hardware.
Otherwise it may result in the unit falling down and causing
personal injury.
Do not use nails, adhesives or other unauthorized devices.
Long-term use and vibrations may cause it to fall easily.
Do not touch or bump the woofer and tweeter. If these are
damaged, the sound will be distorted.
Do not listen to sound at a very high level when you are
changing the input source (for example, to tune FM / CD)
Installation or removal of cables should make sure that
the power amp / amplifier device radio is turned off.
1
2
3
4
5
Power Cable
Rear Panel Specification
LOOP: Signal output, connect to active amplifiers.
4
Remark
5
SUB: Bass output, connect to active amplifiers (SUB a
mplifier is better).
6
Speaker Output: Connect to passive speakers.
7
LED Indicator: During power on mode, light is constant blue
color; During power AUTO mode, lights goes off when there
is no signal input and it turns to blue color when signal comes.
11
Power switch: When this switch is on Auto position, the
amplifier will automatically turn on when a signal is present
and it will go standby when there is no signal input.
1
2
There will be a prompt sound when Bluetooth is connected.
3
Since there is no priority set in audio input, please don't use
Bluetooth and line in inputs simultaneously, otherwise sound
is mixed.