Users Manual

HYF-5BT

8"--

SPEAKER

(PAIR SET)

SPECIFICATIONS

Sensitivity

Nominal Impedance

Frequency Response

Audio Input

Product Dimensions

86dB

183x164x245mm(7.2"x6.5"x9.6")

70Hz-16kHz

300MV-unbalanced

150MV-balanced

Power Supply

AC100-240V

Model

HYF-5BT

Woofer

5.25" PP Cone

Tweeter

0.5" Mylar Dome

Wireless Transmission Distance

10m

Wireless Connection System

Bluetooth V

If you hear the clipping at high volume levels, turn down the

volume until the distortion is gone.

Damage caused by operating the speakers at distorted volume

levels is not covered by the warranty.

Underpower Vs. Overpower

Most speaker damage is caused by amplifiers with too little

power (wattage).

An overdriven amplifier clips the waveforms and leads to

speaker distortion.

Clipping is usually audible and it may vary from a harsh sound

to a fuzzy or unclear sound.

3.0

PAGE 1
4 Underpower Vs. Overpower 1 Most speaker damage is caused by amplifiers with too little power (wattage). 2 An overdriven amplifier clips the waveforms and leads to speaker distortion. 3 Clipping is usually audible and it may vary from a harsh sound to a fuzzy or unclear sound. 4 If you hear the clipping at high volume levels, turn down the volume until the distortion is gone. 5 Damage caused by operating the speakers at distorted volume levels is not covered by the warranty.
PAGE 2
1 SAFETY INSTRUCTIONS 3 Rear Panel Specification INSTALLATION 1 1 When the speakers are installed in the wall, ensure the wall structure is reliable and that the speakers are firmly attached. Tweeter Bracket screws Fixed to the wall or ceiling AUXIN R 2 Install the speaker in a location that can structurally support the weight of the speaker and its mounting hardware. Otherwise it may result in the unit falling down and causing personal injury.
PAGE 3
FCC Statement： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation.