Assembly Instructions

ASSEMBLY INSTRUCTIONS

• Make sure the lamp is disconnected from power before assembly.

• Place the base on a flat surface and insert the stem into the base as shown in the

diagram. Make sure the stem is inserted completely into the base, and twist the stem

tightly.

• Remove bulb from box and handle with soft cloth. Insert bulb pins into the holes in

the lamp head and twist clockwise

/i turn until secure. (Warning: make sure lamp is

unplugged).

• Plug the appliance in and switch on.

• Search bluetooth speaker for the name "RLD”

SAFETY INSTRUCTIONS

A CAUTION

WARNING: DO NOT LIGHT CANDLE WHEN USING CANDLE WARMER

LAMP.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCKAND EXCESSIVE

UV RADIATION, FOLLOW THESE DIRECTIONS FOR USE:

• Read all instructions, including these important safeguards in this manual.

• Lamp is hot when turned on.

• Turn off, unplug and allow lamp to cool before replacing bulb and before

cleaning.

• Do not expose skin to light for long periods of time.

• Do not look directly at lighted lamp.

• Keep lamp away from flammable materials.

• Keep lamp away from materials that may bum.

• Do not touch bulb at anytime. Use a soft cloth when removing or replacing bulbs.

Oil from skin may shorten bulb life.

• Do not operate the lamp if you have missing parts.

• Use a 50 watt candle warmers bulb available from retailer or Amazon.

• Use a soft cloth when replacing bulb.

• Once a candle has been melted by a candle warmerit is not recommended that you

lightthe wickand burn the same candle.

PAGE 1
ASSEMBLY INSTRUCTIONS SAFETY INSTRUCTIONS • Make sure the lamp is disconnected from power before assembly. A CAUTION • Place the base on a flat surface and insert the stem into the base as shown in the diagram. Make sure the stem is inserted completely into the base, and twist the stem tightly. • Remove bulb from box and handle with soft cloth. Insert bulb pins into the holes in the lamp head and twist clockwise y/i turn until secure.
PAGE 2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.