Installation Instructions

This device complies with Part 18 of the FCC Rules. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. If this equipment
FCC Statement
This device complies with part 18 of the FCC Rules. Operation
is Subject To the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation. Changes or
modifications not explicitly approved by the party responsible
for compliance could void the user's authority to operate this
equipment.
Note: this equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
18 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help .
The equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. During the operation of
device a distance of 15 cm surrounding the device and 20 cm
above the top surface of the device must be respected.
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
• Increase the separation between the equipment and any other
radio device.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
ISED Statement
This device complies with Industry Canada’s license-exempt RSS.
Operation is subject to the following two conditions:
• This device may not cause interference; and
• This device must accept any interference, including interference
that may cause undesired operation of the device. Le présent
appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
• l’appareil ne doit pas produire de brouillage;
• l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
RF Exposure Information
This equipment complies with IC RSS-216 radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 10cm
between the radiator and your body.
Informations sur l' exposition aux RF
Cet équipement respecte les limites d'exposition aux
rayonnements IC
RSS-216 fixées pour un environnement non contrôlé.Cet
équipement doit être installé et exploité à une distance minimale
de 10cm entre le radiateur et votre corps.
Multiple cord extension set