User's Manual

Tubular Motor-
DM28CEQ/S
Specification
（A-OO）
DM28CEQ/S
2N.m
12V
433.925MHz
28RPM
1. Don’t operate motors wheuin low wltage alarm：
① Motor stop running When the supply voltage is lower than 7 v， and it will restart
again
when the voltage is greater than 7.5V
②If the voltage is less than 10v, the motor will alarm for 10 times to prompt it needs to
be charged every timewhen the motor is working.
2. Optrating:
①The valid interval of the emitter button is 10s,the emitter will quit the set after 10s
②The motor will run or beep for hint,please do the next step after the hint.
3. Set limit position：
①After the up limit and down limit setting,and the up limit down limit and third limit
position are at the same location
②After limit setting，with power and memory function;
③Into the match-code status 2 minutes later, it will quit out the setting limits status
automatically
④It will delete every memory and restore the factory settings
4. When the motor running without any operation, the maximum running time is 6 minutes,it will
stop automatically
5 If the emitterlost,please set up again with new emitter

READING
12V battery pole
The motor can be charged by both the power
adapter or the 12V supply electricity.Is that is
rechargeable by solar panel or adaptor when
the battery is low.
Product introduction
Functional features：
Jogging&tilt function
Set electronic limit
Set /delete the third limit position
Low standby power
Integrated radio control
Setting up + add emitter +delete emitter
Motor direction setting option
Resistance stop function
Signal wire
-10
85
Operating
temperature
Technical Dare
Emission frequency(MHz)
Type
Rated Torque(N.m)
Rated Voltage(V)
Rated speed(RPM)
①Driving tube must be close-fitting with crown and drive adapter.
②Choose crown and drive adapter based on the driving tube.
Motor Installation
Drive tube
Drive tube
② Runner
① Crown
③ Circlip
Rechargeable Description
Stroke support
Tail insert bracket
Operation note
Please read the fallowngprecautions befor use：