Manualshelf

User's Manual

ManualsBrandsNINGBO DOOYA MECHANIC & ELECTRONIC TECHNOLOGY ManualsElectronicsMotor Remote Control
123
Tubular Motor-
DM18LE/S
Specification
（A-OO）
Rated Voltage(V)
Rated Torque(N.m)
Functional features：
Jogging&tilt function
Set electronic limit
Set /delete the third limit position
Low standby power
Integrated radio control
Setting up+add emitter+delete emitter
Motor direction setting option
Resistance stop function
-10
85
Emission frequency(MHz)
Rated speed(RPM)
1. Please charge the battery and make sure it is fully charged before the first use
2. Don’t operate motors wheuin low wltage alarm:
①
Motor stop running When the supply voltage is lower than 7 v， and it will restart
again when the voltage is greater than 7.5V
②If the voltage is less than 10v, the motor will alarm for 10 times to prompt it needs
to be charged every timewhen the motor is working.
3. Optrating：
①
The valid interval of the emitter button is 10s,the emitter will quit the set after 10s
②The motor will run or beep for hint,please do the next step after the hint.
4. Set limit position：
①
After the up limit and down limit setting,and the up limit down limit and third limit
position are at the same location
②After limit setting，with power and memory function;
③Into the match-code status 2 minutes later, it will quit out the setting limits status
automatically
④It will delete every memory and restore the factory settings
5. When the motor running without any operation, the maximum running time is 6
minutes,it will stop automatically
6. If the emitterlost,please set up again with new emitter
&
The motor has a built-in battery,using the charger to
recharge.You can also use solar panels to charge;when
the battery is low, insert thecharge,charger light shows
red light.batteries isfull when the red light turns to green.
Note：When the battery power is low,you can hear the alarm ten "beep" every time the
motor runs. It indicates the battery needs to be charged. Then plug in the charger with
red light.The light turns green when the battery is fully charged.
Operating
temperature
Parameter
Type
Rechargeable Description
Signal wire
DM18LE/S
0.2N.m
12V
433.925MHz
80RPM

Summary of content (3 pages)